Product Description
T2 Colour Stripes
44mm x 10m lengths
Application:
Ensure the application surface is clean, dry and free from dust and grease. Peel away the backing paper approximately 5cm and position the stripe at the start of the desired line. Unwind and apply to the hull in about 25cm lengths peeling away the backing paper as you do so. As you position the tape, apply gentle pressure to remove any creases and air bubbles. At this stage, it is possible to lift and reposition the stripe taking care not to stretch the tape. Carefully cut each end to the required length using a sharp knife and cutting away from the hull by taking the stripe to the blade. Use a soft cloth to firmly rub over the stripe to ensure a good bond and again, remove any remaining air bubbles. To finish, slowly remove the oversize carrier film where applied.
